Electrical
Services
HT/LT panels and switchgear
Supply, installation and testing of HT and LT panels and switchgear.
What we do
We supply and install high-tension (HT) and low-tension (LT) panels for buildings and factories: from VCB and LBS panels on the incoming side to MCCB/ACB, power factor improvement (PFI) and distribution boards. Every panel is tested before it is switched on.
HT panels: factory-assembled, 14 SWG sheet-steel clad, dust- and vermin-proof, floor-mounted 11 kV and 33 kV switchgear with hard-drawn electrolytic copper busbars, protection relays and metering.
LT panels: sheet-steel clad, floor-mounted 415/240 V, three-phase four-wire switchgear with copper busbars, circuit breakers, protective relays and meters.
Scope of work
- VCB and LBS panels
- MCCB and ACB panels
- Power factor improvement (PFI) panels
- MDB and SDB supply
- Installation and cabling
- Testing and commissioning
- MCC, PCC, PFI, MDB and DB panel boards
Work photos
From our sites
LT switchgear panels
How we work
- 1
Talk to an engineer
Tell us the site, the load and the deadline.
- 2
Site visit
We check the site and existing equipment.
- 3
Proposal
Scope, materials, schedule and a clear quote.
- 4
Execution
Installation, testing, commissioning and handover.
Projects
Projects in this service
Questions
HT/LT panels and switchgear
Can you replace an old panel without a long shutdown?
We plan the work with you so the power cut is as short as possible, often outside working hours.
Why install a PFI panel?
A PFI panel keeps the power factor high. This can reduce penalty charges on industrial bills and the load on cables and transformers.
Also thinking about solar?
The same engineers design rooftop solar for homes, shops and factories.
Planning solar or electrical work?
Get a solar estimate in two minutes, or talk to an engineer about your project today.